Early-Mustang Cowl Repair - Cowl Repairs
- Details
- Category: Restoration Section
- Published on Friday, 29 March 2013 13:03
- Written by Klaus
- Hits: 40980
Page 6 of 7
The following 2 pictures are good side views showing how the panel shaped to the metal, and also how it's sloped so water runs out of it.
This picture here shows a close up of my 'continuous bead' weld. It's actually a combination of a whole bunch of small welds. The flux core mig welder eats up the really thin metal, especially in this cowl area where it was all suspect to begin with.